Skullcandy Dime is an affordable headset compatible with iPhone, iPad, and iPod models. Unfortunately, some people have found this not to be the case, and the headphones do not charge at all after using them from time to time. If your Skullcandy Dime not charging and want to find out how to fix these problems, read on to learn more about this device and how you can improve charging issues if they occur.
5 Ways to Fix Skullcandy Dime Not Charging Issue
Check The Power Source
The Skullcandy Dime is a wireless headphone that charges via a USB cable. We recommend plugging the headphones into your phone and seeing if it turns on. If not, then you may need to replace the battery.
The battery can be replaced by taking off the ear cup and unscrewing the battery cover with a Phillips head screwdriver. You will need a CR-2032 battery which can be found at most stores. Then take off the old battery by pulling gently on one of the terminals to disconnect it from the circuit board and insert the new one in its place.
Reset the power source
If your battery dies and you are unable to charge it, try these steps:
- Make sure that the power button is not held down. This can cause the device to turn off or shut down.
- Please remove the battery from the device and reinsert it.
- Plug in the charging cable into a USB port on your computer, then plug in the other end of the line into a wall outlet or power strip
- Your device should show as charging within 10 minutes.
- When your device shows charging, unplug the power source, wait 5 seconds, reconnect the charger, and wait for your phone to boot up.
Check For Damaged Cables
The most common cause of this issue is a damaged or broken cable. Check the wires around your phone to ensure they are intact and not bent. If you find a damaged line, try another charger with a suitable cable to see if it solves the problem.
Another option would be to plug the headphones into a computer using an auxiliary cord and see if that fixes the issue.
If both solutions don’t work, it may be time for some new headphones! Headphones can only take so much wear and tear before their wires become loose or break altogether. It’s always better to be safe than sorry about expensive electronics like these.
Clean Out The Ports
This may sound elementary, but try cleaning the charging port with a toothpick or cotton swab. If you’re using a headphone jack to charge the device, clean out any dirt and debris that could be blocking it.
Make sure your battery is charged as well. Lastly, avoid leaving your Skullcandy plugged in for too long because it can affect battery life. It’s also important to note that turning on the backlight on your device while plugged in can make it drain faster, so turn off the backlighting while charging if possible.
Update The Firmware
The firmware in the Skullcandy Dime is outdated and needs to be updated. To update the firmware, plug in the headphones with a phone connected by Bluetooth (make sure to pair your phone with your headphones). Once connected, go to Settings, then Software Update, and tap Search. You will see an option that says Update Firmware.
Tapping on this will start the process. The process takes about five minutes. It might seem like it’s not working initially, but if you keep checking the progress bar, you’ll notice it moving. After updating the firmware, restart your headphones by holding down on the power button for 5 seconds until they shut off.
Conclusion
If your Skullcandy Dime not charging, you can take a few steps to determine the issue. Once you’ve solved these problems, press and hold down your Dime until all LED lights flash simultaneously; when they do, let go and wait for them to return to blinking alternately in about 5 seconds. This resets it so you can use it again.
Related Posts:
